How To Replace A GE Oven Faceplate [Quick Guide]

A worn out faceplate doesn’t work as well it normally should. So if you would like to know how to replace a GE oven faceplate, this article is for you.

How To Replace A GE Oven Faceplate

A GE oven faceplate is more commonly known as the touchpad. To replace the touchpad of a GE oven, follow the steps listed below…

Step 1: Unplug the oven or switch off the circuit breaker.

Step 2: Turn the oven around and take out the four screws which hold the upper back panel of the oven in place.

Step 3: Remove the back panel.

Step 4: Take a picture of where the wires go on the control board.

Step 5: Disconnect the wires from the control board.

Step 6: Take out the four screws which secure the control board.

Step 7: Using a putty knife, carefully pry off the touchpad from the control board.

Step 8: Get a new touchpad and stick it to the control board.

Step 9: Screw the control board assembly back and reconnect the wires to the right places on the control board.

Step 10: Reposition the upper back panel of the oven and hold it in place using the screws.

Step 11: Plug the oven back in or turn on the circuit breaker.

Watch the video below for a visual of how to replace a GE oven faceplate or touchpad.

Check out these articles…

GE Oven Will Not Turn Off [How To Fix]

GE Oven Smell [How To Fix]

How To Clean GE Oven Grates [Quick Guide]

GE Oven Handle [Issues & How To Fix]

GE Oven Glass [Problems & Solutions]

GE Range Hood [How To, Issues & Solutions]

GE Stove Knob [Issues & Solutions]

See also  Frigidaire Microwave Light [Issues & Solutions]

Leave a Comment