If your oven isn’t working how it’s supposed to, the first thing you should do is reset it. In this article, we will show you how to reset a Kenmore oven.
Table of Contents
How To Reset A Kenmore Oven After A Power Outage
Below, we show you how to reset a Kenmore oven after a power outage…
Step 1: Locate the circuit breaker of your Kenmore oven.
Step 2: Switch the circuit breaker off.
Step 3: Leave the breaker off for about 10 minutes.
Step 4: After 10 minutes, switch the circuit breaker back on.
How To Reset A Kenmore Oven Control Board
Below, we show how to reset a Kenmore oven control board…
Step 1: Pull the oven away from the wall.
Step 2: Unplug the oven’s power cord from the outlet.
Step 3: Leave the oven unplugged for 5 minutes.
Step 4: After 5 minutes, plug the oven’s power cord back in.
Kenmore Oven F10 Reset
If your oven shows an F10 error code, first reset the control board. If you don’t know how to do this, read the section directly above this one. If that doesn’t fix the problem, the sensor should be replaced. Follow the steps below to replace the temperature sensor of your Kenmore oven…
Step 1: Unplug the oven’s power cord.
Step 2: Open the door of the oven.
Step 3: Slide out the oven racks and set them aside.
Step 4: Using a Philips head screwdriver, take out the two screws which hold the temperature sensor to the oven’s back wall. The sensor is on the upper left corner.
Step 5: Pull the sensor out and disconnect the wire plug from it. Make sure the wire doesn’t fall through the hole in the oven’s back wall.
Step 6: Get a new sensor and connect the wire plug to it.
Step 7: Push the sensor in and hold it in place with the two Philips head screws.
Step 8: Slide the racks back into the oven.
Step 9: Shut the door.
Step 10: Plug the oven’s power cord back into the outlet.
Watch the video below for a visual of how to replace the temperature sensor in a Kenmore oven.
Check out these articles…
How To Reset A Kenmore Oven Clock
To reset the clock of your Kenmore oven, follow the steps listed below…
Step 1: Pull the oven away from the wall and unplug the power cord from the outlet.
Step 2: Leave the oven unplugged for 5 minutes.
Step 3: After 5 minutes plug the power cord back in.
Step 4: Turn the oven on and press the “clock” button.
Step 5: Input your desired time.
Step 6: Press the “clock” button again to save the changes.