If your Zanussi oven is not functioning properly, you should reset it. In this article, we will show you how to reset a Zanussi oven.
Table of Contents
How To Reset A Zanussi Oven
Below, we show you how to reset a Zanussi oven…
Step 1: Pull the oven away from the wall in order to access the power cord.
Step 2: Unplug the power cord from the outlet.
Step 3: Leave the oven unplugged for 10 minutes.
Step 4: After 10 minutes, plug the oven’s power cord back into the outlet.
Step 5: Return the oven to its usual position.
How To Reset A Zanussi Oven After A Power Outage
Below, we show you how to reset a Zanussi oven after a power outage…
Step 1: Locate the circuit breaker of your Zanussi oven.
Step 2: Switch the circuit breaker off.
Step 3: Leave the circuit breaker off for 10 minutes
Step 4: After 10 minutes, switch the circuit breaker back on.
Also follow the steps above to reset a Zanussi built in oven.
If your Zanussi oven won’t work after being reset, the thermal cut out has probably blown. Below, we have listed the steps you need to follow in order to replace the thermal cut out in your Zanussi oven…
Step 1: Locate your Zanussi oven’s circuit breaker.
Step 2: Switch the circuit breaker off to avoid the risk of electrocution.
Step 3: Get a Philips head screwdriver and a Torx head screwdriver.
Step 4: Open the oven door.
Step 5: If your oven is installed to a cabinet, you will need to uninstall it. To do this, use the Philips head screwdriver to take out the screws on the oven’s front frame. There are two screws on each side.
Step 6: Now, carefully lift the oven out of the cabinet.
Step 7: Set the oven on a sturdy surface.
Step 8: Go to the oven’s rear.
Step 9: Using the Torx head screwdriver, take out the screws which hold the oven’s rear access panel in place.
Step 10: Lift the panel off and set it aside.
Step 11: The thermal cut out is near the grill element’s terminals. Note where each wire goes on the thermal cut out. You can take a picture to make it easier.
Step 12: Disconnect the wires from the terminals of the thermal cut out.
Step 13: Take out the screw which holds the thermal cut out in place.
Step 14: Remove the thermal cut out and get a new one.
Step 15: Position the new thermal cut out on the oven’s rear.
Step 16: Hold it in place with the screw.
Step 17: Connect the wires to the new thermal cut out making sure that each one goes to the right place.
Step 18: Reposition the oven’s rear panel.
Step 19: Hold the rear panel in place using the Torx head screws.
Step 20: Lift the oven up and push it back into the cabinet.
Step 21: Secure the oven to the cabinet using the four Philips head screws.
Step 22: Shut the door of the oven.
Step 23: Reconnect the oven’s power by switching the circuit breaker back on.
If your Zanussi oven still won’t work, the control board is faulty. Read this article: Zanussi Oven Is Not Heating [Proven Solutions] to replace the control board in your Zanussi oven.
Watch the video below for a visual of how to replace the thermal cut out in an oven.